Search

DIY EMF Reference Module by Ghost Gear


Operation

Once everything is connected and powered up EMF1 and EMF2 will deliver 5V when an EMF is detected. The blue LED indicates the power is on.


Connections

9V Power In – connect a 9 Volt battery terminal here (not included)

Switch – connect an on/off switch here or use a jumper to power up the device. (Jumper comes installed)

5V Out – a constant 5 volts out

GND – ground connection

EMF1 – This will go to 5V high when EMF is detected

EMF2 – This will go to 5V high when EMF is detected

Not Used – these connections are not used

External Antenna – insert a 22 AWG solid core wire into either connector (included)

18 views0 comments

Recent Posts

See All